TRENDnet TL2-E284 - SNTP Daylight Saving Time

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
5-10
Figure 23 – System > SNTP > Time Settings
Parameter
Description
Current Time
Current system time.
SNTP Status
To enable/disable the Simple Network Time Protocol (SNTP) function. Default
is disabled.
SNTP Poll Interval in
Seconds (30-86400)
To set the time interval that SNTP synchronizes the time on SNTP server, and
the range is from 30 to 86400 seconds. Default is 30.
SNTP Primary Server
To set the primary SNTP server IP address.
SNTP Secondary
Server
To set the secondary SNTP server IP address.
Time Zone Offset
(HH:MM)
To specify the difference of current time zone relative to GMT.
Year:Month:Day
Specify current date
HH:MM:SS
Specify current system time.
Click Apply to submit the changes.
SNTP Daylight Saving Time
This page is to configure the daylight saving time function of system time setting.
Figure 24 – System > SNTP > Daylight Saving Time
Parameter
Description
Daylight Saving Time
Status
To enable/disable the DST function. Default is disabled.
Daylight Saving Time:
From
(Month:Day:HH:MM)
Specify the DST period in month:day:hour:minute.