TRENDnet TL2-E284 - Ip Igmp Snooping Querier-Query-Interval; Ip Igmp Snooping Report-Forward

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
32-4
Command
ip igmp snooping port-purge-interval <(130 - 1225) seconds>
no ip igmp snooping port-purge-interval
Syntax Description
(130-1225)
seconds
Specify the port purge interval.
Default Settings
260 seconds
Command Modes
Global Configuration Mode
User Guidelines
Using no form to reset the port purge interval to default.
Example
switch(config)# ip igmp snooping port-purge-interval 150
Command History
Version
History
1.00.001
This command was introduced
ip igmp snooping querier-query-interval
To set up the time interval to send the IGMP general query.
Command
ip igmp snooping querier-query-interval <(60 - 600) seconds>
no ip igmp snooping querier-query-interval
Syntax Description
(60-600) seconds
Specify the time interval of general query.
Default Settings
125 seconds
Command Modes
Global Configuration Mode
User Guidelines
Using no form to reset the query interval to default.
Example
switch(config)# ip igmp snooping querier-query-interval 150
Command History
Version
History
1.00.001
This command was introduced
ip igmp snooping report-forward
To configure which kind of ports that IGMP snooping reports should be forwarded.