TRENDnet TL2-E284 - Snmp Trap Link-Status; Show Snmp

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
17-10
Command History
Version
History
1.00.001
This command was introduced
snmp trap link-status
To enable sending link-status Trap message, and no form disables it
Command
snmp trap link-status
no snmp trap link-status
Default Settings
Disabled
Command Modes
Interface Configuration Mode
Example
switch(config-if)# snmp trap link-status
Command History
Version
History
1.00.001
This command was introduced
show snmp
To display the SNMP settings
Command
show snmp
Command Modes
Privileged EXEC Mode