TRENDnet TL2-E284 - Dot1 X Max-Start; Dot1 X Port-Control

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
31-6
User Guidelines
Using no form to reset the number of retry to default.
Example
switch(config-if)# dot1x max-req 10
Command History
Version
History
1.00.001
This command was introduced
dot1x max-start
To set the maximum EAPOL retries of the authenticator.
Command
dot1x max-start <count(1-65535)>
no dot1x max-start
Syntax Description
count(1-65535)
Specify the number of retry.
Default Settings
3 retries
Command Modes
Interface Configuration Mode
User Guidelines
Using no form to reset the number of retry to default.
Example
switch(config-if)# dot1x max-start 10
Command History
Version
History
1.00.001
This command was introduced
dot1x port-control
To set the authenticator control on ports.
Command
dot1x port-control {auto | force-authorized |
force-unauthorized}
no dot1x port-control
Syntax Description
auto
Enable the 802.1X authentication on this port, and
the port authorized or unauthorized will based on the
802.1X authentication result.
force-authorized
All traffic is transparent to the port.
force-unauthorized
All traffic is blocked to the port.