TRENDnet TL2-E284 - Sntp Poll-Interval; Sntp Primary-Ip

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
21-3
Syntax Description
from
Time that DST startis from
january ~ december
Specify the month that DST starts.
day (1-31)
Specify the day that DST starts.
hour (0-23)
Specify the hour that DST starts.
minute (0-59)
Specify the minute that DST starts.
to
Time that DST ends from
january ~ december
Specify the month that DST ends.
day (1-31)
Specify the day that DST ends.
hour (0-23)
Specify the hour that DST endts.
minute (0-59)
Specify the minute that DST ends.
Command Modes
Global Configuration Mode
Example
switch(config)# sntp dst from april 1 0 0 to September 1 0 0
Command History
Version
History
1.00.001
This command was introduced
sntp poll-interval
To set the time interval that SNTP synchronizes the time on SNTP server.
Command
sntp poll-interval <seconds (30-86400)>
Syntax Description
seconds (30-86400)
Specify the time interval that SNTP synchronizes the
time on SNTP server.
Default Settings
30 seconds
Command Modes
Global Configuration Mode
Example
switch(config)# sntp poll-interval 3600
Command History
Version
History
1.00.001
This command was introduced
sntp primary-ip
To set the primary SNTP server IP address.