TRENDnet TL2-E284 - Chapter 30 Link Aggregation Command; Link Aggregation Command List; Set Port-Channel; Lacp System-Priority

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
30-1
Chapter 30
Link Aggregation Command
Link Aggregation Command List
 set port-channel
 lacp system-priority
 port-channel load-balance
 channel-group
 lacp port-priority
 lacp timeout
 lacp wait-time
 shutdown port-channel
 show etherchannel
 show lacp
 show interfaces etherchannel
set port-channel
To enable or disable port channel function of the Switch.
Command
set port-channel { enable | disable }
Syntax Description
enable
Enables the port channel.
disable
Disables the port channel.
Default Settings
Disable
Command Modes
Global Configuration Mode
Example
switch(config)# set port-channel enable
Command History
Version
History
1.00.001
This command was introduced
lacp system-priority
To set the LACP priority of the Switch.
Command
lacp system-priority <0-65535>
no lacp system-priority