TRENDnet TL2-E284 - Set Garp Timer

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
27-2
Syntax Description
interface-type
interface-id
Specify which port to enable GVRP function.
Interface-type including Fa (Fast Ethernet) or Gi (Gigabit
Ethernet).
Interface-id is slot/port number.
enable
Enables GVRP on the port.
disable
Disables GVRP on the port.
Default Settings
Enable
Command Modes
Global Configuration Mode
User Guidelines
If port GVRP is disabled, but global GVRP is enabled, any GVRP packet received
by this port will be discarded and no GVRP registrations will be propagated from
other ports
Example
switch(config)# set port gvrp fa 0/1 disable
Command History
Version
History
1.00.001
This command was introduced
set garp timer
To set the GARP timers on an interface.
Command
set garp timer {join <time in milli seconds(10-1073741810)> |
leave <time in milli seconds(30-2147483630)> | leaveall<time
in milli seconds(40-2147483640)>}
Syntax Description
join <time in milli
seconds(10-1073741810)>
Specify the join time of GARP.
leave <time in milli
seconds(30-2147483630)>
Specify the leave time of GARP.
leaveall<time in milli
seconds(40-2147483640)>
Specify the leaveall time of GARP.
Default Settings
Join - 20
Leave - 60
Leaveall - 100
Command Modes
Interface Configuration Mode
User Guidelines
1. Leave timer must be greater than 2 times join time.
2. Leaveall time must be greater than Leave time
Example
switch(config-if)# set garp timer join 50
Command History
Version
History
1.00.001
This command was introduced