TRENDnet TL2-E284 - Ip Arp Max-Retries; Arp

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
15-2
Note
The IP address of Management VLAN interface must be assigned by a DHCP
server.
ip arp max-retries
To set the maximum number of ARP request retries.
Command
ip arp max-retries <value (2-10)>
no ip arp max-retries
Syntax Description
value (2-10)
Number of ARP request retries.
Default Settings
3
Command Modes
Global Configuration Mode
User Guidelines
The no form resets the number of retries to default value.
Example
switch(config)# ip arp max-retries 4
Command History
Version
History
1.00.001
This command was introduced.
arp
To add a static entry in the switch ARP table.
Command
arp <ip address> <hardware address> {Vlan <vlan-id(1-4094)> |
<interface-type> <interface-id> | Linuxvlan <interface-name>|
Cpu0}
no arp <ip address>
Syntax Description
ip address
IP address of the network node.
hardware address
MAC address of the network node.
Vlan
vlan-id(1-4094)
VLAN id
interface-type
interface-id
Interface type and id of the interface connects to the ARP
entry.
Interface-type including Fa (Fast Ethernet) or Gi (Gigabit
Ethernet).
Interface-id is slot/port number.
Linuxvlan
interface-name
Interface name of Linux VLAN interface.
Cpu0
Out-of-band management interface.