TRENDnet TL2-E284 - Chapter 38 Rate Limiting Command; Rate Limiting Command List; Rate-Limit Egress; Rate-Limit Ingress

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
38-1
Chapter 38
Rate Limiting Command
Rate Limiting Command List
 rate-limit egress
 rate-limit ingress
 show rate-limit
rate-limit egress
To enable and setup the egress packet rate limiting on a port.
Command
rate-limit egress [<rate-value(64~1000000)>]
no rate-limit egress
Syntax Description
rate-value
(64~1000000)
Specify the traffic Kbit per second is allowed to be transmitted
for an egress port..
Default Settings
Disable
Command Modes
Interface Configuration Mode
User Guidelines
The no form is to disable the rate limiting on a port.
Example
switch(config-if)# rate-limit egress 64
Command History
Version
History
1.00.001
This command was introduced
rate-limit ingress
To enable and setup the ingress packet rate limiting on a port.
Command
rate-limit ingress [<rate-value (64~1000000)>]
no rate-limit ingress
Syntax Description
rate-value
(64~1000000)
Specify the traffic Kbit per second is allowed to be received
for an ingress port.
Default Settings
Disable