TRENDnet TL2-E284 - Storm Control Settings; P Queue Mapping

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
8-2
Figure 72 – QoS > Rate Limiting
Parameter
Description
Select
Select a port to configure rate limiting function.
Port
Port ID.
Ingress RateLimit
(0,64~1000000 Kbps)
Specify the traffic Kbit per second is allowed to be transmitted for an ingress
port. 0 means no limit.
Egress RateLimit
(0,64~1000000 Kbps)
Specify the traffic Kbit per second is allowed to be transmitted for an egress
port. 0 means no limit.
Click Apply to submit the changes.
Click 1-12, 13-24, 25-28 to configure rate limiting for corresponding ports.
Storm Control Settings
This page is to configure the storm control function of the device.
Figure 73 – QoS > Storm Global Settings
Parameter
Description
System Control
To activate or shutdown storm control function of the Switch. Select Enable to
activate link aggregation function, Disabled to shutdown it. Default is Start.
Packet Type
Specify which kind of packets to be controlled. The options are:
Broadcast only - Control broadcast packets only.
Multicast and Broadcast - Control both multicast and broadcast packets.
DLF and Multicast and Broadcast - Control Destination Lookup Failed
unicast, multicast and broadcast packets.
Rate Limit
Specify the maximum packet rate is allowed per second.
802.1p Queue Mapping
This page is to configure the 802.1p priority and queue mapping.