TRENDnet TL2-E284 - Show Lacp

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
30-9
Number of Ports = 1
HotStandBy port = null
Port state = Port-channel Ag-Not-Inuse
Protocol = LACP
MAC selection = Dynamic
Default Port = None
switch# show etherchannel 1 summary
Port-channel Module Admin Status is enabled
Port-channel Module Oper Status is enabled
Port-channel System Identifier is 00:74:24:00:01:00
Maximum ports per Port Channel is 8 with maximum 8 active ports
Flags:
D - down P - in port-channel
I - stand-alone S - suspended
H - Hot-standby (LACP only)
Number of channel-groups in use: 1
Number of aggregators: 1
Group Port-channel Protocol Ports
---------------------------------------------------------
1 Po1(D) LACP Gi0/1(D)
switch# show etherchannel 1 protocol
Channel Group Listing
---------------------
Group : 1
----------
Protocol : LACP
Command History
Version
History
1.00.001
This command was introduced
show lacp
To display the LACP port channel counters or neighbors information.
Command
show lacp [<port-channel(1-65535)>] { counters | neighbor
[detail] }
Syntax Description
port-channel
(1-65535)
Specify the information of which port channel to display.
counters
Displays the traffic statistics.
neighbor
Displays the neighbot information.
detail
Displays the detailed neighbot information.