TRENDnet TL2-E284 - Snmp-Server Enable Traps Snmp Authentication

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
17-8
excluded
Excludes the object from the list that the SNMP administrator
can access
volatile
Store in volatile memory
nonvolatile
Store in nonvolatile memory
Default Settings
View Name : iso
Subtree OID : 1
Subtree Mask : 1
View Type : Included
Storage Type : Non-volatile
------------------------------
View Name : ReadWrite
Subtree OID : 1
Subtree Mask : 1
View Type : Included
Storage Type : Non-volatile
------------------------------
View Name : restricted
Subtree OID : 1
Subtree Mask : 1
View Type : Included
Storage Type : Non-volatile
Command Modes
Global Configuration Mode
Example
switch(config)# snmp view operv2readview 1.3.6.1 mask 1.1.1.1
included nonvolatile
Command History
Version
History
1.00.001
This command was introduced
snmp-server enable traps snmp authentication
To enable the authentication trap messages for SNMP v1 and v2c, and the no
form disables it.
Command
snmp-server enable traps snmp authentication
no snmp-server enable traps snmp authentication
Default Settings
Disabled
Command Modes
Global Configuration Mode
Example
switch(config)# snmp-server enable traps snmp authentication
Command History
Version
History
1.00.001
This command was introduced