TRENDnet TL2-E284 - Chapter 18 Ssh Command; Ssh Command List; Ssh; Ip Ssh

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
18-1
Chapter 18
SSH Command
SSH Command List
 ssh
 ip ssh
 debug ssh
 show ip ssh
ssh
To activate the SSH server function on the switch. The no format is to turn it off.
Command
ssh {enable | disable}
Syntax Description
enable
To turn on the SSH server function.
disable
To turn off the SSH server function.
Default Settings
Enabled
Command Modes
Global Configuration Mode
Example
switch(config)# ssh enable
Command History
Version
History
1.00.001
This command was introduced
ip ssh
To configure the SSH server settings. The no format will cancel the settingand go
back to default value.
Command
ip ssh {version compatibility | cipher ([des-cbc] [3des-cbc])
| auth ([hmac-md5] [hmac-sha1]) }
no ip ssh {version compatibility | cipher ([des-cbc] [3des-cbc])
| auth ([hmac-md5] [hmac-sha1]) }