TRENDnet TL2-E284 - Set Sntp Dst; Sntp Dst

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
21-2
Syntax Description
enable
Enables the SNTP.
disable
Disables the SNTP.
Default Settings
Disable
Command Modes
Global Configuration Mode
Example
switch(config)# set sntp enable
Command History
Version
History
1.00.001
This command was introduced
set sntp dst
To enable/disable the Daylight Saving Time (DST) function of SNTP.
Command
set sntp dst {enable | disable}
Syntax Description
enable
Enables the DST function.
disable
Disable the DST function.
Default Settings
Disable
Command Modes
Global Configuration Mode
Example
switch(config)# set sntp dst enable
Command History
Version
History
1.00.001
This command was introduced
sntp dst
To configure the period of DST function.
Command
sntp dst from {january | february | march | april | may | june
| july | august | september | october | november | december}
<day (1-31)> <hour (0-23)> <minute (0-59)> to {january |
february | march | april | may | june | july | august | september
| october | november | december} <day (1-31)> <hour (0-23)>
<minute (0-59)>