TRENDnet TL2-E284 - Show Interface Mtu

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
44-3
Syntax Description
interface-type
interface-id
Specify the information of which interface to display.
Interface-type including Fa (Fast Ethernet) or Gi (Gigabit
Ethernet).
Interface-id is slot/port number.
description
Display the link status and protocol status of the interface
flowcontrol
Display the flow control setting and pause frame statistic
of the interface
capabilities
Display the capabilities of the interface
status
Display the current status of the interface
port-channel
port-channel-id
(1-65535)
Port channel ID
Command Modes
Privileged EXEC Mode
User Guidelines
System will display information of all interfaces when executing the command
without given parameters.
Example
switch# show interface fa 0/5 description
Interface Status Protocol
--------- ------ --------
Fa0/5 up up
switch# show interface fa 0/5 flowcontrol
Port Tx FlowControl Rx FlowControl Tx Pause Rx Pause
---- -------------- ------------- -------- --------
Fa0/5 off off 0 0
switch# show interface fa 0/5 capabilities
Fa0/5
Type : 10/100/1000 Base TX
Speed : 10, 100, 1000, Auto
Duplex : Half, Full
FlowControl : Send, Receive
switch# show interface fa 0/5 status
Port Status Duplex Speed Negotiation
---- ------ ------ ----- -----------
Fa0/5 connected Full 100 Mbps Auto
Copper
Command History
Version
History
1.00.001
This command was introduced.
show interface mtu
To display the MTU setting of the interface.