TRENDnet TL2-E284 - Snmp-Server Enable Traps; Snmp-Server Trap Udp-Port

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
17-9
snmp-server enable traps
To enable specific SNMP trap message types, and no form disable them.
Command
snmp-server enable traps {firewall-limit | linkup | linkdown
| sip-states |sip-cfg-change | coldstart | poe-power |
dhcp-pool-limit | dsx1-line}
no snmp-server enable traps {firewall-limit | linkup | linkdown|
sip-states | sip-cfg-change | coldstart | poe-power |
dhcp-pool-limit | dsx1-line}
Syntax Description
firewall-limit
linkup
Interfaces are linked up
linkdown
Interfaces are linked down
sip-states
The change of SIP protocol state
sip-cfg-change
The change of SIP configuration
coldstart
The switch is power cycled
poe-power
dhcp-pool-limit
dsx1-line
Default Settings
Linkup and Linkdown messages are enabled
Command Modes
Global Configuration Mode
Example
switch(config)# snmp enable traps poe-power
Command History
Version
History
1.00.001
This command was introduced
snmp-server trap udp-port
To specify the UDP port for sending SNMP trap messages
Command
snmp-server trap udp-port <port>
no snmp-server trap udp-port
Syntax Description
<port>
UDP port number
Default Settings
162
Command Modes
Global Configuration Mode
Example
switch(config)# snmp-server trap udp-port 10162