TRENDnet TL2-E284 - Permit (Extended IP Access List Configuration)

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
35-8
permit (Extended IP Access List Configuration)
To configure a rule that packets matched will be processed.
Command
permit { ip | ospf | pim | <protocol-type (1-255)>} { any | host
<src-ip-address> | <src-ip-address> <mask> } { any | host
<dest-ip-address> | <dest-ip-address> <mask> } [ {tos <value
(0-7)> | dscp <value (0-63)>} ]
permit {tcp | udp} {any | host <src-ip-address> |
<src-ip-address> <src-ip-mask>} {anyport | <src-port
(1-65535)> <x8000 | xC000 | xE000 | xF000 | xF800 | xFC00 | xFE00
| xFF00 | xFF80 | xFFC0 | xFFE0 | xFFF0 | xFFF8 | xFFFC | xFFFE
| xFFFF>} {any | host <dest-ip-address> | <dest-ip-address>
<dest-ip-mask>} {anyport | <dest-port (1-65535)> <x8000 | xC000
| xE000 | xF000 | xF800 | xFC00 | xFE00 | xFF00 | xFF80 | xFFC0
| xFFE0 | xFFF0 | xFFF8 | xFFFC | xFFFE | xFFFF>} [ {tos <value
(0-7)> | dscp <value (0-63)>} ] [{ ack | ack-not }][{ rst |
rst-not }]