TRENDnet TL2-E284 - Deny (MAC Access List Configuration)

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
35-2
Command
ip access-list { standard <access-list-number (1-1000)> |
extended <access-list-number (1001-65535)> }
no ip access-list { standard <access-list-number (1-1000)> |
extended <access-list-number (1001-65535)> }
Syntax Description
standard
access-list-number
(1-1000)
Specify the ID to a standard IP access control list.
extended
access-list-number
(1001-65535)
Specify the ID to a extended IP access control list.
Command Modes
Global Configuration Mode
User Guidelines
1. Using no form to delete the access control list.
2. The ID cannot be duplicated for all access control list.
Example
switch(config)# ip access-list standard 200
switch(config-std-nacl)#
Command History
Version
History
1.00.001
This command was introduced
deny (MAC Access List Configuration)
To configure a rule that packets matched will be filtered.
Command
deny { any | host <mac-address>}{ any | host <mac-address> }
[aarp | amber | dec-spanning | decnet-iv | diagnostic | dsm |
etype-6000 | etype-8042 | lat | lavc-sca | mop-console | mop-dump
| msdos | mumps | netbios | vines-echo | vines-ip | xns-id |
<protocol (0-65535)>] [ Vlan <vlan-id (1-4094)>]