TRENDnet TL2-E284 - Lacp Timeout; Lacp Wait-Time

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
30-4
User Guidelines
The port priority decides the standby or active links in a aggregation when the
number of member port exceeds the maximum number of the etherchannel that
Switch supported.
Example
switch(config-if)# lacp port-priority 1
Command History
Version
History
1.00.001
This command was introduced
lacp timeout
To choose the LACP timeout period when no packet receive from peer..
Command
lacp timeout {long | short }
no lacp timeout
Syntax Description
long
Specify a long time out value. LACP PDU will be sent every
30 seconds and LACP timeout value is 90 seconds
short
Specify a short time out value. LACP PDU will be sent every 1
seconds and LACP timeout value is 3 seconds
Default Settings
Long
Command Modes
Interface Configuration Mode
Example
switch(config-if)# lacp timeout short
Command History
Version
History
1.00.001
This command was introduced
lacp wait-time
The period that ports get aggregated after receiving LACP PDU.
Command
lacp wait-time <0-10>
no lacp wait-time
Syntax Description
0-10
Specify the wait time in seconds.
Default Settings
2 seconds
Command Modes
Interface Configuration Mode