TRENDnet TL2-E284 - Show Nvram

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
12-8
Command
show system information
Command Modes
Privileged EXEC mode
Example
switch# show system information
Hardware Version : Rev.A1
Firmware Version : 1.00.002
Switch Name : SysName
System Contact : SysContact
System Location : SysLocation
Logging Option : Console Logging
Login Authentication Mode : Local
Config Save Status : Not Initiated
Remote Save Status : Not Initiated
Config Restore Status : Successful
Web Timeout Interval : 600
Cli Timeout Interval : 18000
Command History
Version
History
1.00.001
This command was introduced.
show nvram
To display the current information stored in NVRAM.
Command
show nvram
Command Modes
Privileged EXEC mode
Example
switch# show nvram
Default IP Address : 192.168.10.200
Default Subnet Mask : 255.255.255.0
Default IP Address Config Mode : Manual
Default IP Address Allocation Protocol : DHCP
Switch Base MAC Address : 00:74:24:00:02:00
Default Interface Name : Fa0/1
Default RM Interface Name : NONE
Config Restore Option : Restore
Config Save Option : Startup save
Config Save IP Address : 0.0.0.0
Config Save Filename : iss.conf
Config Restore Filename : iss.conf
PIM Mode : Sparse Mode
IGS Forwarding Mode : MAC based
Cli Serial Console : Yes
SNMP EngineID : 80.00.08.1c.04.46.53
SNMP Engine Boots : 2
Default VLAN Identifier : 1