TRENDnet TL2-E284 - Ip Access-Group; Show Access-Lists

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
35-12
ip access-group
To apply an IP access control list from the port.
Command
ip access-group <access-list-number (1-65535)>
no ip access-group [<access-list-number (1-65535)>]
Syntax Description
access-list-number
(1-65535)
Command Modes
Interface Configuration Mode
User Guidelines
Using no form to dissociate ACL from the port.
Example
switch(config-if)# ip access-group 1001
Command History
Version
History
1.00.001
This command was introduced
show access-lists
To display the details of configured access lists.
Command
show access-lists [[{ip | mac}] <access-list-number
(1-65535)> ]
Syntax Description
ip
To disply IP access control list.
mac
To display MAC access control list.
access-list-number
(1-65535)
Specify the ID of access control list.
Command Modes
Privileged EXEC Mode
User Guidelines
System will display all access list information without a given IP or MAC access
list number.
Example
switch# show access-lists mac 1
Extended MAC Access List 1
-----------------------------
EtherType : 0
Vlan Id : 0
Destination MAC Address : 00:00:00:00:00:00
Source MAC Address : 00:00:00:00:00:00
In Port List : NIL
Filter Action : Permit
Status : InActive