TRENDnet TL2-E284 - Chapter 40 Qos Command; Qos Command List; Set Dscp; Vlan Map-Priority

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
40-1
Chapter 40
QoS Command
QoS Command List
 set dscp
 vlan map-priority
 dscp map-type
 cosq scheduling algorithm
 switchport priority default
 show vlan traffic-classes
 show vlan port config
 show dscp
 show cosq algorithm
set dscp
To configure the priority and switch queue mapping
Command
set dscp { enable | disable }
Syntax Description
enable
Enables DSCP and queue mapping.
disable
Disables DSCP and queue mapping.
Default Settings
Disable
Command Modes
Global Configuration Mode
User Guidelines
When DSCP is disabled, Switch map queue with 802.1p priority.
Example
switch(config)# set dscp enable
Command History
Version
History
1.00.001
This command was introduced
vlan map-priority
To set the 802.1p priority and queue mapping.
Command
vlan map-priority <priority value(0-7)> traffic-class
<Traffic class value(0-3)>