TRENDnet TL2-E284 - Dot1 X Default; Dot1 X Max-Req

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
31-5
dot1x default
To configure 802.1X with default values on the port.
Command
dot1x default
Default Settings
Per-interface 802.1X protocol enable state - Enabled (force-authorized)
Periodic reauthentication - Disabled
Number of seconds between
reauthentication attempts - 3600 seconds
Quiet period - 60 seconds
Retransmission time - 30 seconds
Maximum retransmission number - 2 times
Client timeout period - 30 seconds
TX period - 30 seconds
Defaults authentication server timeout
period - 30 seconds
Command Modes
Interface Configuration Mode
Example
switch(config-if)# dot1x default
Command History
Version
History
1.00.001
This command was introduced
dot1x max-req
To set the maximum 802.1X Extensible Authentication Protocol (EAP) retries of
the client before restarting authentication process.
Command
dot1x max-req <count(1-10)>
no dot1x max-req
Syntax Description
count(1-10)
Specify the maximum number of retry.
Default Settings
2 retries
Command Modes
Interface Configuration Mode