TRENDnet TL2-E284 - Chapter 22 Configuration Command; Configuration Command List; Write; Copy Startup Config Copy Erase

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
22-1
Chapter 22
Configuration Command
Configuration Command List
 write
 copy startup-config
 copy
 erase
write
To save the running configuration.
Command
write { flash:filename | startup-config |
tftp://ip-address/filename }
Syntax Description
flash:filename
Write to a designated flash driver with designated file
name.
startup-config
Write to start up configuration.
tftp://ip-address
/filename
Write to a remote TFTP site with designated file name.
Command Modes
Privileged EXEC Mode
Example
switch# write start-config
Command History
Version
History
1.00.001
This command was introduced
copy startup-config
To backup the startup configuration to NV-RAM or a remote site.
Command
copy startup-config { flash: filename |
tftp://ip-address/filename }
Syntax Description
flash:filename
Copy to a designated flash driver with designated file
name.
tftp://ip-address
/filename
Copy to a remote TFTP site with designated file name.
Command Modes
Privileged EXEC Mode