TRENDnet TL2-E284 - Show Spanning-Tree Mst

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
29-5
Command Modes
Interface Configuration Mode
User Guidelines
Use no form to reset the hello time value to default.
Example
switch(config-if)# spanning-tree mst hello-time 1
Command History
Version
History
1.00.001
This command was introduced
show spanning-tree mst
To display the information of MST instances.
Command
show spanning-tree mst [<instance-id(1-64)>] [detail]
Syntax Description
instance-id(1-64)
Specify information of which MST instance to show.
detail
Display more details of MST instance information.
Command Modes
Privileged EXEC Mode
User Guidelines
System will display MST information for all instances when executing the
command without instance-id parameter.
Example
switch# show spanning-tree mst 1
## MST01
Vlans mapped: 2
Bridge Address 00:50:ba:fd:51:49 Priority 32768
Root Address 00:50:ba:fd:51:49 Priority 32768
Root this switch for MST01
Interface Role Sts Cost Prio.Nbr Type
--------- ---- --- ---- -------- ----
Fa0/1 Master Forwarding 2000000 128.1 SharedLan
switch# show spanning-tree mst 1 detail
## MST01
Vlans mapped: 2
Bridge Address 00:50:ba:fd:51:49 Priority 32768
Root Address 00:50:ba:fd:51:49 Priority 32768
Root this switch for MST01
Fa0/1 of MST01 is Master , Forwarding
Port info port id 128.1 priority 128 cost 2000000
Designated root address 00:50:ba:fd:51:49 priority 32768 cost
0
Designated bridge address 00:50:ba:fd:51:49 priority 32768 port
id 128.1