TRENDnet TL2-E284 - Clear Spanning-Tree Counters; Debug Spanning-Tree

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
28-7
Example
switch(config)# shutdown spanning-tree
Command History
Version
History
1.00.001
This command was introduced
clear spanning-tree counters
To clear the spanning tree counters.
Command
clear spanning-tree counters
Command Modes
Global Configuration Mode
Example
switch(config)# clear spanning-tree counters
Command History
Version
History
1.00.001
This command was introduced
debug spanning-tree
To enable the debug mode for spanning tree function.
Command
debug spanning-tree { global | { all | errors | init-shut |
management | memory | bpdu | events | timer | state-machine
{ port-info | port-recieve | port-role-selection |
role-transition | state-transition | protocol-migration |
topology-change | port-transmit | bridge-detection } |
redundancy | sem-variables}}
no debug spanning-tree {global | {all | errors | init-shut |
management | memory | bpdu |events | timer | state-machine
{port-info | port-recieve | port-role-selection |
role-transition | state-transition | protocol-migration |
topology-change | port-transmit | bridge-detection } redundancy
| sem-variables}}