TRENDnet TL2-E284 - Show Vlan Port Config

24-Port 10/100Mbps Layer 2 Switch w/ 4 Gigabit Ports and 2 Shared Mini-GBIC Slots
26-8
Example
Single Instance:
switch# show vlan device info
Vlan device configurations
--------------------------
Vlan Status : Enabled
Vlan Oper status : Enabled
Gvrp status : Disabled
Gvrp Oper status : Disabled
Bridge Mode : Customer Bridge
Traffic Classes : Enabled
Vlan Operational Learning Mode : IVL
Version number : 1
Max Vlan id : 4095
Max supported vlans : 256
Multiple Instance:
switch# show vlan device info
Switch default
Vlan device configurations
--------------------------
Vlan Status : Enabled
Vlan Oper status : Enabled
Gvrp status : Enabled
Gmrp status : Disabled
Gvrp Oper status : Enabled
Gmrp Oper status : Disabled
Mac-Vlan Status : Disabled
Protocol-Vlan Status : Enabled
Bridge Mode : Provider Edge
Bridge
Traffic Classes : Enabled
Vlan Operational Learning Mode : IVL
Version number : 1
Max Vlan id : 4094
Max supported vlans : 1024
Command History
Version
History
1.00.001
This command was introduced
show vlan port config
To display the VLAN configurations of ports.
Command
show vlan port config [{port <interface-type> <interface-id>}]
Syntax Description
port interface-type
interface-id
Specify which port to show VLAN configurations.
Interface-type including Fa (Fast Ethernet) or Gi
(Gigabit Ethernet).
Interface-id is slot/port number.