Service and maintenance
176 Manual m600 basic 2.6_01
15
Service and
maintenance
Storage of ink
cartridges
The ink cartridges should be stored at room temperature (ambient tem-
perature of print system) ± 5° C deviation. A temperature of 18-25° C
and a relative humidity of 35-55 % would be ideal.
Whenever the printer is not used for any lengthy period, it is advisable to
remove the cartridges from the mounts and to store them in the protec-
tive caps which are available as options (to protect the nozzle plate from
drying out). (Wolke art. no. 660035)
Cleaning the
cartridges
Cleaning of the ink cartridge is required before the cartridge is to be rein-
serted, or if the print image has deteriorated visibly.
15 Service and maintenance
15.1 Information on care
INFORMATION ON CARE
If the display is soiled, it can be cleaned using a commer-
cially available moist screen cleaning wipe.
INFORMATION ON CARE
Dust on the contact pins of the print head can be evacu-
ated using a vacuum pump or be removed with a fine
paintbrush.
To this effect, the m600 basic must be switched off!
15.2 Storage of ink cartridges
15.2.1 Cleaning the cartridges
Before replacing the ink cartridge, check it visually for leakage!
(Make sure ink does not leak.)
Check the contact film visually for oxidation and mechanical
damage.
Do not use the cartridge if it is not in correct working order.
If necessary, replace the cartridge.
INFORMATION ON CARE
If the nozzle plate should become soiled, clean it with an
absorbent, lint-free, damp cotton wool cloth. A cleaning
kit is optionally available (Art. nr.660040).
Always make sure that the cartridge is dry before you re-
insert it.
To Next Page
Loading...