Xerox WorkCentre 6605

Error Troubleshooting
Phaser 6600 and WorkCentre 6605 Xerox Internal Use Only
Service Manual
2-148
034 799 No Dial Data Auto dial is activated but
no dial data exist.
Fax Number Error 034-799
No dial Data, please confirm and
enter fax number or try again.
Job canceled.
* Caution screen with [Close]
button
Replace the
Fax Board.
035 701 Send T1 Time Out In send, T1 timeout Target Fax is Not Answering 035-
701
T1 time out, no response detected
from remote device.
Job canceled. Confirm fax number
and contact receiving party if issue
persists.
* Caution screen with [Close]
button
Replace the
Fax Board.
035 702 Receive DCN DCN receive Fax Communication Error 035-
702
Disconnect signal received from
remote device.
Job canceled. Remote device will
try again.
* Caution screen with [Close]
button
Replace the
Fax Board.
035 704 Not Send Ability Remote device has no
ability to send.
Fax Communication Error 035-
704
Please check remote device if error
persists.
Job canceled.
* Caution screen with [Close]
button
Replace the
Fax Board.
035 705 DCS/NSS Resend
Over
DCS/NSS resend over. Fax Communication Error 035-
705
Digital Command Signal/Non-
standard Setup error.
Job canceled. Please try again.
* Caution screen with [Close]
button
Replace the
Fax Board.
WorkCentre 6605 Error Code List
Chain Link Error Error Details Control Panel Messages
FIP
location