Required Tools and Equipment
Required Tools and Equipment
l Utility knife or scissors
l ESD-preventive wrist strap or other personal grounding device
l Suitable grounded surface or a static-dissipative mat
l Purchase order or equipment list
l Installation Overview — SH12 and SH4R Shelves
l Installation Overview — 4U Shelf
l Installation Overview — 1U Shelf
l Site Preparation Checklist
l Unpacking the SH12 and SH4R Shelves
l Unpacking a 4Uor 1UShelf
l Inspecting the FSP 3000 C Equipment
Unpacking the SH12 and SH4R Shelves
Each SH12 and SH4R shelf is securely packaged in a shipping box. Depending on how
you ordered your system, your shelf may ship empty or with a minimum number of
modules installed.
This procedure assumes that your shelf shipped empty. When unpacking
the SH12, ADVA Optical Networking recommends using a lift.
1. Attach a ground strap to your wrist and snap the ground wire to the wrist band. Insert
the ground plug into a grounded ESD jack.
2. Inspect the shipping boxes for evidence of damage during shipment. Claims for
damage during shipment must be asserted promptly with the transportation company
involved. If any damage or other signs of mishandling are evident, inform both the
freight carrier and ADVA Optical Networking before unpacking. Your freight carrier
can provide you with the procedures necessary to file a claim for damages.
3. Move the shipping box to a staging area as close to the installation site as possible,
where you have enough room to remove the shelf and components from the boxes.
Make sure that the shipping box has been in the installation location for a
minimum period of 24 hours to avoid thermal shock and surface
condensation when unpacking.
176 FSP3000 C Hardware Guide - R1.1 - Issue:A (12/09/2016)
To Next Page
Loading...