Adva FSP 3000 - Removing and Installing a Module Slot Cover; Required Tools and Equipment; Removing a Module Slot Cover

Required Tools and Equipment
Chapter 36
Removing and Installing a Module Slot
Cover
Required Tools and Equipment 305
Removing a Module Slot Cover 305
Installing a Module Slot Cover 306
Required Tools and Equipment
l ESD-preventive wrist strap or other personal grounding device
l Appropriate slot cover
l Slot Covers
l FSP 3000 C General Safety Guidelines and Warnings
Removing a Module Slot Cover
1. Verify that you are properly grounded with an anti-static wrist strap or heel strap
connected to the grounded ESDjack.
2. If mounted, remove the front cover from the shelf as described in Removing and
Installing Front Covers.
3. Loosen the thumb screws.
4. Grasp the thumb screws and carefully slide the slot cover away from the shelf.
l Electrostatic Discharge Damage Prevention and Warning
l General Installation and Maintenance Guidelines
l Operational Risks
FSP3000 C Hardware Guide - R1.1 - Issue:A (12/09/2016) 305