Adva FSP 3000 - Installing a Traffic Module

Installing a Traffic Module
l Traffic module
l Appropriate pluggable transceiver (if applicable)
CAUTION
The use of pluggable transceivers other than those approved and
released by ADVA Optical Networking will result in loss of laser safety
approval for the respective module and entire FSP 3000 C system. Only
approved pluggable transceivers will guarantee the behavior in
conjunction with the module as specified.
To ensure your safety, as well as the warranty, reliability and
compatibility of your FSP 3000 C system, use original ADVA parts and
components only.
l Installation Overview — SH12 and SH4R Shelves
l Traffic Module Support
l Module and Pluggable Transceiver Compatibility
l Handling Modules
l Handling Pluggable Transceivers
Installing a Traffic Module
This procedure assumes that:
l The shelf is properly grounded to the rack; and
l The shelf and module have been properly inspected.
ELECTRIC VOLTAGEWARNING
Risk of short circuit.
If a backplane connector of a shelf has bent or broken off pins, do
not slide in the traffic module into that shelf slot. If the plug-in
board connector of the traffic module is damaged, do not install
this module.
Damaged connectors could cause a short circuit or malfunction.
1. Use your installation plan to verify the following information about the traffic module
you are installing
o
What type of traffic module you are installing
o
Which shelf will house the traffic module
o
Which slot will house the traffic module
FSP3000 C Hardware Guide - R1.1 - Issue:A (12/09/2016) 221