Adva FSP 3000 - Removing and Installing Front Covers; Required Tools and Equipment

Required Tools and Equipment
Chapter 35
Removing and Installing Front Covers
Required Tools and Equipment 301
Removing a Shelf Front Cover 301
Installing the SH12 Upper Front Cover 302
Installing the SH12 Lower Front Cover 302
Installing the SH4RFront Cover 303
Installing the FD-128D Front Cover 304
Required Tools and Equipment
l ESD-preventive wrist strap or other personal grounding device
l Appropriate front cover(s) for the FSP 3000 C shelf
l Shelf Front Covers
l Electrostatic Discharge Damage Prevention and Warning
l General Electrical Safety Guidelines and Warnings
Removing a Shelf Front Cover
1. Verify that you are properly grounded with an anti-static wrist strap or heel strap
connected to the grounded ESD jack.
2. Using your forefingers, simultaneously push in the latches on both sides of the front
cover and gently pull the cover toward you at the same time.
3. Remove the cover and lay it aside.
l Electrostatic Discharge Damage Prevention and Warning
l Cooling and Airflow— SH12
l Cooling and Airflow — SH4R
l Shelf Front Covers
FSP3000 C Hardware Guide - R1.1 - Issue:A (12/09/2016) 301