Adva FSP 3000 - Page 182

Inspecting the FSP 3000 C Equipment
9. Carefully unpack each pluggable transceiver and place it on a static-dissipative mat.
10. Compare the pluggable transceivers you received to your order. Report any
discrepancies to ADVA Optical Networking immediately.
11. Inspect each pluggable transceiver visually
o
Verify that the optical port of the module is equipped with a dust plug. If not, install
one.
o
Check for any impurities present on the pluggable transceiver. If necessary, use
canned, dry, oil-free compressed air to blow off any impurities.
Leave the pluggable transceivers on the mat until you are ready to install
them.
12. If no damage was discovered for the shelf or any modules, proceed to the next
chapter to install the shelf.
13. If you have discovered any damage, have incorrect components, or are missing any
equipment:
a. If any damage has occurred during transportation, immediately report the extent
of damage by filing a claim with the transportation company. Notify your ADVA
Optical Networking customer service representative or ADVA Optical
Networking. Have the following information ready:
o
Invoice number of shipper
o
Name of the damaged unit
o
Serial number and item number of the damaged unit
o
Description of damage
o
Effect of damage on the installation
If damaged equipment must be returned to the factory, refer to Returning Equipment.
Order replacement equipment, if necessary.
b. If any standard item is missing, notify your ADVA Optical Networking customer
service representative or ADVA Optical Networking immediately.
c. If the configuration of the system is not conforming to the ordered one, follow your
company policy or contact ADVA Optical Networking customer service
representative or ADVA Optical Networking.
For contact details, see the Preface.
l Installation Overview — SH12 and SH4R Shelves
l Installation Overview — 4U Shelf
l Installation Overview — 1U Shelf
l Unpacking the SH12 and SH4R Shelves
l Unpacking a 4Uor 1UShelf
l General Safety Guidelines and Warnings
l Handling Equipment Precautions and Guidelines
l Electrostatic Discharge Damage Prevention and Warning
182 FSP3000 C Hardware Guide - R1.1 - Issue:A (12/09/2016)