Appendix C 485
GPIB command table
GPIB command list sorted according to function
1. Chapter Title
C. GPIB Command table 3. Chapter Title
4. Chapter Title
5. Chapter Title
Fixture
compensation
Standard for data measurement Definition Open “DCOMOPEN{G|C}” on page 293
Short “DCOMSHOR{R|L}” on page 294
Load “DCOMLOAD{R|L}” on page 292
Display Defined value “COMS” on page 281
On/Off “COMST{A|B|C}” on page 282
Data measurement point setting (User/Fixed) “CALP” on page 275
Data for compensation
coefficient calculation
Measurement “COM{A|B|C}” on page 281
Input data “INPUCOMC{1-3}” on page 321
Output data “OUTPCOMC{1-3}?” on page 374
Measurement Sweep Mode setting Continuous “CONT” on page 282
Hold “HOLD” on page 318
Operation Single “SING” on page 437
Specified number “NUMG” on page 364
Trigger Source selection “TRGS” on page 459
Polarity of external trigger signal “TRGP” on page 458
Trigger event mode “TRGEVE” on page 458
GPIB/LAN triggering “*TRG” on page 261
Data
read/write
Data transfer
format selection
ASCII format “FORM4” on page 317
IEEE 32-bit floating point format “FORM2” on page 316
IEEE 64-bit floating point format “FORM3” on page 316
MS-DOS personal computer format “FORM5” on page 317
Read Data array All measurement points “OUTPDATA?” on page 375
Specified measurement point “OUTPDATAP?” on page 375
Memory array All measurement points “OUTPMEMO?” on page 385
Specified measurement point “OUTPMEMOP?” on page 385
Data trace array All measurement points “OUTPDTRC?” on page 378
Specified measurement point “OUTPDTRCP?” on page 379
Memory trace array All measurement points “OUTPMTRC?” on page 388
Specified measurement point “OUTPMTRCP?” on page 389
User calibration data array “OUTPCALC{1-3}?” on page 373
Fixture compensation data array “OUTPCOMC{1-3}?” on page 374
Sweep parameter array All measurement points “OUTPSWPRM?” on page 394
Specified measurement point “OUTPSWPRMP?” on page 394
level
monitor
result
OSC Voltage All measurement points “OUTPVAC?” on page 394
Specified measurement point “OUTPVACP?” on page 395
Current All measurement points “OUTPIAC?” on page 380
Specified measurement point “OUTPIACP?” on page 381
DC bias All measurement points “OUTPDC?” on page 376
Specified measurement point “OUTPDCP?” on page 376
Limit test
result
All measurement points “OUTPLIML?” on page 383
Marker position “OUTPLIMM?” on page 384
Failed measurement points “OUTPLIMF?” on page 383
Number of failed measurement points “OUTPFAIP?” on page 380
Occurred error information (Error queue) “OUTPERRO?” on page 380
Function Setting/Operation GPIB command
To Next Page
Loading...
Need help?
General
