Traffic policing margin
Only active when the traffic policing test is enabled. Allows you to specify a
margin for the pass/fail evaluation during the service configuration test. The
test will fail if the throughput is greater than CIR + EIR + Margin.
Frame transfer delay / RT Frame transfer delay
Allows you to specify the maximum acceptable transfer delay in ms (mean).
Frame delay variation / RT Frame delay variation
Allows you to specify the maximum acceptable frame transfer deviation in
ms (mean).
Frame loss rate
Allows you to specify the maximum acceptable frame loss rate.
AVAIL
Allows you to specify the minimum acceptable availability percentage.
Color Aware tab
The Color Aware tab page contains the following parameters:
To Next Page
Loading...
