9.3 Reflector
In Fiber Channel Reflector mode, the Network Master loops incoming traffic on a
port, swapping ID addresses.
9.3.1 Ports Setup and Status
The first step in running an application is to set up the port interfaces. This is
done on the Ports Setup screen, which also provides port status
information.
The setup options and status information related to the Fibre Channel
interface are described in a separate section:
FC Setup and Status
For applications also including an OTN interface, you can find a description
of the setup options and status information for OTN in the following section:
OTN Setup and Status
Please refer to the sections relevant for your current port setup
requirements.
9.3.2 Test Setup
9.3.2.1 Control
When you go to the test setup of the Fibre Channel Reflector application, the
following screen is displayed.
For operation, refer to Control in "BERT" section。
To Next Page
Loading...
