Traffic generator
Status, Results
User-defined Jumbo frame size upper limit (1519 to 16000 bytes)
*: Only for Ethernet 10/100/1000 Mbps (cannot use 10Gbps)
Line load profile
Constant: 0.0008% - 100%
Ramp:
Line load: start, end, step (0.0001% resolution)
Duration: 3 to 3600 seconds
Ramp mode: Keep end line load, Repeat ramp, Invert ramp
Frame size profile
Constant
Stepped:
Frame size: start, end, step (to 16000 bytes)
Duration: 1 to 3600 seconds
Random:
Frame size: start, end (to 16000 bytes),
User-defined TCP/UDP frame size upper limit (2048 bytes)
Traffic duration
Continuous
Seconds: 1 to 2,000,000,000
Frames: 1 to 2,000,000,000
Unicast/broadcast
User-defined traffic mix of unicast and broadcast frames
VLAN
User-defined VLAN ID and VLAN priority
Address
Configurable IP and Ethernet source and destination addresses
(supports IPv4 and IPv6 addressing). Fixed, DHCP, DNS.
Flow control
Generate pause frames
Respond to pause frames
ARP
Answer incoming ARP request On/Off
IP
Fixed or incremented IP identifier
User programmable DSCP/TOS byte
UDP/TCP
User programmable UDP/TCP address
UDP Checksum: automatic or fixed (null)
TCP checksum: automatic
Status
Link status, RF, Signal present, Jabber detected, Frames present, Speed,
Full or half duplex, Interface type, Local clock (Ethernet 1000), Pause
capable and Asymmetric pause request (excluding 10Gbps), Link partner
capabilities (excluding 10Gbps)
Resolution
User-defined resolution for statistical measurements:
1, 2, 5, 10, 15, 30s, 1, 5, 15, 30 minutes, 1, 2, 4, 6, 12 hours.
To Next Page
Loading...
