Anritsu Network Master Pro MT1000A - Page 417

OH Edit
TTI measurement
MSIM Detection
Alarm Insertion
Error Insertion
Frequency Offset
Payload Offset
Alarm Detection
All OTU, ODU bytes except MFAS and BIP8
TTI, FTFL bytes with multi-frame manner
Condition for detecting TIM can be selected.
TCM measurement On/Off
Expected MSI bytes are set from Tx Data or Received Data.
11.3.3.2 OTN Stimuli
OTU, ODU
*
OTU-AIS, OOF/LOF, OOM/LOM, SM-TIM, SM-BIAE, SM-BDI, SM-IAE,
ODU-AIS, ODU-OCI, ODU-LCK, PM-TIM, PM-BDI, FSF, FSD, BSF, BSD,
TCMi-TIM, TCMi-BIAE, TCMi-BDI, TCMi-IAE, TCMi-LTC (i=1-6)
Multiplexed ODU
OOF/LOF, OOM/LOM, ODU-AIS, ODU-OCI, ODU-LCK, PM-TIM, PM-BDI, FSF,
FSD, BSF, BSD
Client
Client-AIS, CSF
Insertion timing
Single, Burst, Alternate, All
*: Available for both of Normal mode and Through mode
OTU, ODU
*
Bitall, FAS, MFAS, SM-BIP8, SM-BEI, PM-BIP8, PM-BEI, TCMi-BIP8, TCMi-BEI
(i=1-6), Uncorrectable Error, Correctable Error
Multiplexed ODU
FAS, PM-BIP8, PM-BEI
GMP
CRC8, CRC5, Invalid JC1, Invalid JC2,Invalid JC1&JC2
GFP
cHEC, tHEC, Superblock CRC, eHEC, FCS, CMF
Inserted Error bits are editable.
Client
Bit Error
Insertion timing
Single, Burst, Alternate, Rate, Rate (Random for Bitall), All
*: Available for both of Normal mode and Through mode
±50 ppm 1 ppm step
Movement type
AMP
Burst Insertion (Positive(+1), Positive(+2), Negative (-1))
GMP
Offset (ppm)
Offset
AMP
-131 ppm to +83 ppm (Depending on mapping configuration)
0.1 ppm step
GMP
-150 ppm to +150 ppm 0.1 ppm step
11.3.3.3 OTN Measurement
OTU, ODU
LOS, OTU-AIS, LOF, OOF, LOM, OOM, SM-TIM, SM-BIAE, SM-BDI, SM-IAE,
ODU-AIS,ODU-OCI, ODU-LCK, PM-TIM, PM-BDI, FSF, FSD, BSF, BSD, MSIM,
TCMi-TIM, TCMi-BIAE, TCMi-BDI, TCMi-IAE, TCMi-LTC (i=1-6)
Multiplexed ODU
LOFLOM, OOF, OOM, ODU-AIS,ODU-OCI, ODU-LCK, PM-TIM, PM-BDI, MSIM
Client
Client-AIS, PLM, CSF, LSS
Specifications Measurement functionality
MT1000A Network Master Pro Page 417