Error Detection
Justification
analysis
OH Capture
Transceiver
APS
Measurement
OTN Performance
Measurement
Tributary Scan
Round Trip Delay
Port mode
Topology
Framing
OTU, ODU
FAS, MFAS, SM-BIP8, SM-BEI, FEC Corrected, FEC Uncorrectable, PM-BIP8,
PM-BEI, TCMi-BIP8, TCMi-BEI (i=1-6)
Multiplexed ODU
FAS, MFAS, PM-BIP8, PM-BEI
GFP
cHEC corrected, cHEC uncorrectable, tHEC corrected,
tHEC uncorrectable, CSF Signal, CSF Sync, Invalid GFP Frame,
Superblock CRC, eHEC corrected, eHEC uncorrectable, FCS,
CMF Sync, CMF Signal, SSF, PTI Mismatch, UPI Mismatch
Client
Bit Error
Count
AMP
Positive(+1), Positive(+2), Negative (-1), offset(ppm)
GMP
CRC8 Error, CRC5 Error, Inc, Inc>1, Inc>2, Inc Over, Dec, Dec>1, Dec>2,
Dec Over, offset(ppm), Cm(t) Max, Cm(t) Min
OTU/ODU/OPU OH, Multiplexed ODU/OPU OH
TTI bytes, FTFL bytes with Multi-frame Manner
Update timing
Repeat 1sec, Single
Module Present
Transceiver Information
Alarm, Wavelength and bit rate, Compliance, Vendor Information, Output
Control
Power monitor
Result : Average switching time, Maximum switching time, Minimum
switching time
Trigger
Start Trigger, Stop Trigger
Measurement Range
0.001 to 10.000 ms
Error Free Period
1, 10, 100, 200, 300, 400, 500, 600, 700, 800, 900 and 1000 ms
Standard
ITU-T Rec. G.8201, M.2401(M.2110)
Supports up to 10 Gbps.
Detected Alarms
OTU-AIS, LOF, OOF, LOM, OOM, SM-BIAE, SM-BDI, SM-IAE, ODU-AIS, ODU-
OCI, ODU-LCK, PM-BDI, LOFLOM
Result : RTD Time
Measurement Range
0.5sec, 1sec, 2sec, 5sec, 10sec
Measurement Timing
Single, Repeat
11.3.4 Fibre Channel
Off, FC100, FC200, FC400, FC800, FC1200
Point to Point, Fabric
SOF:Data:EOF, SOF:Header:Data:CRC:EOF
To Next Page
Loading...
