Alarm Insertion
Error Insertion
Frequency Offset
Alarm Detection
Error Detection
Remote status
Link
Transceiver
BER Test
Pass Through
no HDLC, 240 kbit/s, 480 kbit/s, 960 kbit/s, 1920 kbit/s, 2400 kbit/s,
Highest possible
Ethernet
On, Off
Pointer: 20 to 63
Item
Signal Loss, LOS, LOF, LSS, Remote-LOS, Remote-LOF, RAI, SDI, Reset
Item
LCV, SHV, K30.7, Pattern error
Insertion timing
Manual, Rate
±100 ppm 1 ppm step
Signal loss, LOS, LOF, LSS
LCV, SHV, K30.7, Pattern error
Remote LOS, Remote LOF, RAI, SDI, Reset
Rx
Protocol version, HDLC rate, Pointer P
Tx
Protocol version, HDLC rate, Pointer P
Module Present
Transceiver Information
Alarm, Wavelength and bit rate, Compliance, Vendor Information, Output
Control
Power monitor
Alarm:
Signal loss, LOS, LOF, LSS, Remote LOS, Remote LOF, RAI, SDI, Reset
Errors:
LCV, SHV, K30.7, Pattern error
Frames count:
Rx hyper frame, Rx code words, Tx hyper frame, Tx code words
Delay
Delay, Average Delay, Min Delay, Max Delay, Measurement count
Alarm:
Signal loss, LOS, LOF, Remote LOS, Remote LOF, RAI, SDI, Reset
Errors:
LCV, SHV, K30.7
11.4 Optical Modules
To Next Page
Loading...
