Load Save
Touch this icon to open Load/Save dialog box. You can load or save Setup file
or Result file. Only files matching the current application type are selectable for
loading.
When loading setup files, the number of port resources enclosed in the file has
to match that of the current application.
When loading result files, the exact physical ports enclosed in the file has to
match that of the current application.
Apart from actual results, result files also contain settings sampled at the time
the test was performed. When loading result files these settings will overwrite
current application settings.
Loading result files into a viewer will not take up port resources on the system.
This is practical if you only want to review previous results and don't need to run
test again. From the Result File Browser, select the result file you want to view
and touch the View icon ( ) at right hand top of the screen.
Stimuli setup
Various fields and buttons are available for setting up a stimulus signal to
provoke a special or abnormal situation during the test. When the signal has
been specified, the stimulus is sent by touching the Alarm/Error Insert
icon ( ).
The stimulus signal is sent via the transmitter, and the received signal can
simultaneously be inspected as a related status or result display. This allows
to evaluate the behavior of the device under test.
The setup options vary depending on the stimulus mode (i.e. the signal
type). Common functions for all stimulus modes are the port selection and
stimulus type drop-down menus. Touching the Clear all stimuli button
clears/resets the current stimulus settings.
In case of applications having traffic generation, the Traffic start button or the
Traffic stop button appears for each port.
4.3 Startup and Switch-off Sequences
To Next Page
Loading...
