AudioCodes Mediant 800 MSBG - Table 3-14: CAS State Machine Parameters Description

SIP User's Manual 100 Document #: LTRT-12804
Mediant 800 MSBG
4. Once you have completed the configuration, activate the trunk if required in the 'Trunk
Settings' page, by clicking the trunk number in the 'Related Trunks' field, and in the
'Trunk Settings' page, select the required Trunk number icon, and then click Apply
Trunk Settings.
5. Click Submit, and then reset the device (see ''Resetting the Device'' on page 334).
Table 3-14: CAS State Machine Parameters Description
Parameter Description
Generate Digit On Time
[CasStateMachineGenerateDigitO
nTime]
Generates digit on-time (in msec).
The value must be a positive value. The default value is -1
(use value from CAS state machine).
Generate Inter Digit Time
[CasStateMachineGenerateInterDi
gitTime]
Generates digit off-time (in msec).
The value must be a positive value. The default value is -1
(use value from CAS state machine).
DTMF Max Detection Time
[CasStateMachineDTMFMaxOnDet
ectionTime]
Detects digit maximum on time (according to DSP detection
information event) in msec units.
The value must be a positive value. The default value is -1
(use value from CAS state machine).
DTMF Min Detection Time
[CasStateMachineDTMFMinOnDet
ectionTime]
Detects digit minimum on time (according to DSP detection
information event) in msec units. The digit time length must be
longer than this value to receive a detection. Any number may
be used, but the value must be less than
CasStateMachineDTMFMaxOnDetectionTime.
The value must be a positive value. The default value is -1
(use value from CAS state machine).
MAX Incoming Address Digits
[CasStateMachineMaxNumOfInco
mingAddressDigits]
Defines the limitation for the maximum address digits that
need to be collected. After reaching this number of digits, the
collection of address digits is stopped.
The value must be an integer. The default value is -1 (use
value from CAS state machine).
MAX Incoming ANI Digits
[CasStateMachineMaxNumOfInco
mingANIDigits]
Defines the limitation for the maximum ANI digits that need to
be collected. After reaching this number of digits, the collection
of ANI digits is stopped.
The value must be an integer. The default value is -1 (use
value from CAS state machine).
Collet ANI
[CasStateMachineCollectANI]
In some cases, when the state machine handles the ANI
collection (not related to MFCR2), you can control the state
machine to collect ANI or discard ANI.
 [0] No = Don't collect ANI.
 [1] Yes = Collect ANI.
 [-1] Default = Default value - use value from CAS state
machine.
Digit Signaling System
[CasStateMachineDigitSignalingS
ystem]
Defines which Signaling System to use in both directions
(detection\generation).
 [0] DTMF = Uses DTMF signaling.
 [1] MF = Uses MF signaling (default).
 [-1] Default = Default value - use value from CAS state
machine.