SIP User's Manual 210 Document #: LTRT-12804
Mediant 800 MSBG
3.3.2.12.5.2 Configuring IP-to-IP Inbound Manipulations
The 'IP to IP Inbound Manipulation' page allows you to configure up to 100 manipulation
rules for manipulating the SIP URI user part (source and destination) of inbound SIP dialog
requests. You can apply these manipulations to different SIP dialog message types (e.g.,
INVITE or REGISTER).
Manipulated destination URI user part are done on the following SIP headers:
Request-URI, To, and Remote-Party-ID (if exists)
Manipulated source URI user part are done on the following SIP headers: From, P-
Asserted (if exists), P-Preferred (if exists), and Remote-Party-ID (if exists)
Notes:
• For a specific manipulation rule to be effective, the incoming SIP dialog
must match the configured characteristics.
• SIP URI host name (source and destination) manipulations are
configured in the 'IP Group' table (see ''Configuring IP Groups'' on page
119). These manipulations are simply host name substitutions with the
names defined for the source and destination IP Groups respectively.
• The 'IP to IP Inbound Manipulation' table can also be configured using
the ini file table parameter IPInboundManipulation (see ''SBC
Parameters'' on page 858).
¾ To configure IP-to-IP inbound manipulation rules:
1. Open the 'IP to IP Inbound Manipulation' page (Configuration tab > VoIP menu >
SBC submenu > Manipulations SBC submenu > IP to IP Inbound).
Figure 3-110: IP to IP Inbound Manipulation Page
2. Add an entry and then configure it according to the table below.
3. Click the Apply button to save your changes.
4. To save the changes to flash memory, see ''Saving Configuration'' on page 336.
To Next Page
Loading...
