SIP User's Manual 554 Document #: LTRT-12804
Mediant 800 MSBG
d. In the 'SRD' field, enter "1" to associate it with the WAN SRD (defined in
''Step 5: Configure Multiple SIP and RTP Interfaces'' on page 550).
e. From the 'Classify By Proxy Set' drop-down list, select 'Enable' to allow the
device to classify incoming calls as this IP Group based on the Proxy Set.
f. Click Submit.
Figure 8-68: IP Group 2 (for WAN ITSP) in IP Group Table
4. Save the settings to flash memory ("burn") and reset the device (see ''Saving
Configuration'' on page 336).
8.4.10.1.8 Step 8: Define Classification Rules for LAN Users
The procedure below describes how to configure Classification rules for classifying LAN
users. In our case study, the rule classifies them to the USER-type IP Group #1.
¾ To configure Classification rules for LAN users:
1. Open the 'Classification Table' page (Configuration tab > VoIP menu > SBC
submenu > Routing SBC submenu > Classification Table).
2. In the 'Source SRD ID' field, enter '0'. This is the LAN SRD configured in ''Step 5:
Configure Multiple SIP and RTP Interfaces'' on page 550.
3. In the 'So
urce IP Address' field, enter the IP address of the LAN users (IP phones).
You can enter the IP address range "10.8.6.*" to represent these IP phones.
To Next Page
Loading...
