SIP User's Manual 302 Document #: LTRT-12804
Mediant 800 MSBG
5. In the 'VLAN ID' field, enter a value for the VLAN ID, and then click Next. If you chose
to create the VLAN over the WAN, skip to Step 9. If you chose to create the VLAN
over the LAN bridge, the following page appears.
Figure 3-237: Assigning VLAN to LAN Ports
6. From the 'Traffic on this VLAN is' drop-down list, select one of the following:
• 'Untagged': the VLAN is determined based on information such as the ID of a port
on which the data arrives (PVID).
• 'Tagged': adds a tag header (a 32-bit label serving as a VLAN ID) to the frames
transferred over the VLAN.
Note: If the created virtual network is intended for VLAN-unaware hosts, it is
recommended that you select the 'Untagged' option.
7. In the 'VLAN Ports' group, select the LAN bridge ports on which you want to enable
the VLAN.
8. Click Next; a summary of the VLAN configuration is displayed.
Figure 3-238: VLAN Added Successfully
9. Select the 'Edit the Newly Created Connection' check box if you want to edit the new
connection after clicking Finish.
10. Click Finish to save the settings; the new VLAN interface is added to the network
connections list.
To Next Page
Loading...
