Version 6.2 547 February 2011
SIP User's Manual 8. IP Telephony Capabilities
The figure below illustrates the example scenario setup:
Figure 8-58: SBC Example Scenario
8.4.10.1.1 Step 1: Configure LAN VoIP IP Address
The procedure below describes how to configure the VoIP LAN IP addresses (in our
example, 10.8.6.86). This interface is for the OAMP, Media, and Control interface
applications and is assigned the name "Voice".
¾ To configure the VoIP LAN IP address
1. Open the ‘IP Settings’ page, (Configuration tab > VoIP menu > Network > IP
Settings).
2. Select the 'Index' corresponding to Application Type "OAMP + Media + Control" (i.e.,
VoIP and management interface), and then click Edit.
3. Configure the new IP address, prefix length, and default gateway so that it
corresponds to your network IP scheme (e.g., 10.8.6.86).
4. Click Apply and then Done to apply and validate settings. If validation fails, the device
does not reboot.
Figure 8-59: Multiple Interface Table
5. Save the settings to flash memory ("burn") and reset the device (see ''Saving
Configuration'' on page 336).
To Next Page
Loading...
