AudioCodes Mediant 800 MSBG - 3.3.2.11 GW and IP to IP

Version 6.2 145 February 2011
SIP User's Manual 3. Web-Based Management
4. From the 'Profile Preference' drop-down list, select the priority of the IP Profile, where
'1' is the lowest priority and '20' is the highest. If both IP and Tel profiles apply to the
same call, the coders and other common parameters (noted by an asterisk) of the
preferred Profile are applied to that call. If the Preference of the Tel and IP Profiles is
identical, the Tel Profile parameters are applied.
Note: If the coder lists of both IP and Tel Profiles apply to the same call, only the
coders common to both are used. The order of the coders is determined by the
preference.
5. Configure the IP Profile's parameters according to your requirements.
6. From the 'Coder Group' drop-down list, select the coder group that you want to assign
to the IP Profile. You can select the device's default coders (see ''Configuring Coders''
on page 139), or on
e of the coder groups you defined in the 'Coder Group Settings'
page (see ''Configuring Coder Groups'' on page 140).
7. Rep
eat steps 2 through 6 for the next IP Profiles (optional).
8. Click the Submit button to save your changes.
9. To save the changes to flash memory, see ''Saving Configuration'' on page 336.
3.3.2.11 GW and IP to IP
The GW and IP to IP submenu configures the gateway as well as IP-to-IP parameters and
includes the following page items:
 Trunk Group (see Hunt Group on page 145)
 Manipul
ations (see Manipulation on page 151)
 Routin
g (see Routing on page 164)
 DTMF a
nd Supplementary (see ''DTMF and Supplementary'' on page 177)
 Analog Gate
way (see Analog Gateway on page 179)
 Digital Gate
way (see Digital Gateway on page 190)
 Advance
d Applications (see Advanced Applications on page 193)
Note: The IP-to-IP application will be supported in the next applicable release.
3.3.2.11.1 Hunt Group
The Hunt Group submenu allows you to configure groups of channels called Hunt Groups.
This submenu includes the following page items:
 Hunt Group Table (see Configuring Hunt Group Table on page 146)
 Hunt G
roup Settings (see ''Configuring Hunt Group Settings'' on page 148)