SIP User's Manual 734 Document #: LTRT-12804
Mediant 800 MSBG
12.11.3 Fax and Modem Parameters
The fax and modem parameters are described in the table below.
Table 12-31: Fax and Modem Parameters
Parameter Description
Web: Fax Transport Mode
EMS: Transport Mode
[FaxTransportMode]
Fax transport mode used by the device.
[0] Disable = transparent mode
[1] T.38 Relay (default)
[2] Bypass
[3] Events Only
Note: This parameter is overridden by the parameter IsFaxUsed.
If the parameter IsFaxUsed is set to 1 (T.38 Relay) or 3 (Fax
Fallback), then FaxTransportMode is always set to 1 (T.38 relay).
EMS: V34 Transport Method
[V34FaxTransportType]
Determines the V.34 fax transport method (whether V34 fax falls
back to T.30 or pass over Bypass).
[0] = Transparent
[1] = Relay (default)
[2] = Bypass
[3] = Transparent with Events
Note: To configure V34FaxTransportType to 1 (i.e., fax relay),
you also need to configure FaxTransportMode to 1 (fax relay).
Web: Fax Relay Enhanced
Redundancy Depth
EMS: Enhanced Relay
Redundancy Depth
[FaxRelayEnhancedRedundanc
yDepth]
Number of times that control packets are retransmitted when
using the T.38 standard.
The valid range is 0 to 4. The default value is 2.
Web: Fax Relay Redundancy
Depth
EMS: Relay Redundancy Depth
[FaxRelayRedundancyDepth]
Number of times that each fax relay payload is retransmitted to
the network.
[0] = No redundancy (default).
[1] = One packet redundancy.
[2] = Two packet redundancy.
Note: This parameter is applicable only to non-V.21 packets.
Web: Fax Relay Max Rate (bps)
EMS: Relay Max Rate
[FaxRelayMaxRate]
Maximum rate (in bps) at which fax relay messages are
transmitted (outgoing calls).
[0] 2400 = 2.4 kbps
[1] 4800 = 4.8 kbps
[2] 7200 = 7.2 kbps
[3] 9600 = 9.6 kbps
[4] 12000 = 12.0 kbps
[5] 14400 = 14.4 kbps (default)
[6] 16800bps = 16.8 kbps
[7] 19200bps = 19.2 kbps
[8] 21600bps = 21.6 kbps
[9] 24000bps = 24 kbps
To Next Page
Loading...
