AudioCodes Mediant 800 MSBG - M Etering Tone Parameters

SIP User's Manual 828 Document #: LTRT-12804
Mediant 800 MSBG
12.12.9.3 Metering Tone Parameters
The metering tone parameters are described in the table below.
Table 12-59: Metering Tone Parameters
Parameter Description
Web: Generate Metering
Tones
EMS: Metering Mode
[PayPhoneMeteringMode]
Determines the method used to configure the metering tones that are
generated to the Tel side.
 [0] Disable = Metering tones aren't generated (default).
 [1] Internal Table = Metering tones are generated according to the
internal table configured by the parameter ChargeCode.
Notes:
 This parameter is applicable only to FXS interfaces.
 If you select 'Internal Table', you must configure the 'Charge Codes
Table' (see ''Configuring Charge Codes Table'' on page 181).
Web: Analog Metering
Type
EMS: Metering Type
[MeteringType]
Determines the metering method for generating pulses (sinusoidal
metering burst frequency) by the FXS port.
 [0] 12 KHz (default) = 12 kHz sinusoidal bursts
 [1] 16 KHz = 16 kHz sinusoidal bursts
 [2] = Polarity Reversal pulses
Notes:
 For this parameter to take effect, a device reset is required.
 This parameter is applicable only to FXS interfaces.
Web: Analog TTX Voltage
Level
EMS: TTX Voltage Level
[AnalogTTXVoltageLevel
]
Determines the metering signal/pulse voltage level (TTX).
 [0] 0V = 0 Vrms sinusoidal bursts
 [1] 0.5V = 0.5 Vrms sinusoidal bursts (default)
 [2] 1V = 1 Vrms sinusoidal bursts
Notes:
 For this parameter to take effect, a device reset is required.
 This parameter is applicable only to FXS interfaces.
Web: Charge Codes Table
EMS: Charge Codes
[ChargeCode]
This ini file table parameter configures metering tones (and their time
intervals) that the device's FXS interface generates to the Tel side.
The format of this parameter is as follows:
[ChargeCode]
FORMAT ChargeCode_Index = ChargeCode_EndTime1,
ChargeCode_PulseInterval1, ChargeCode_PulsesOnAnswer1,
ChargeCode_EndTime2, ChargeCode_PulseInterval2,
ChargeCode_PulsesOnAnswer2, ChargeCode_EndTime3,
ChargeCode_PulseInterval3, ChargeCode_PulsesOnAnswer3,
ChargeCode_EndTime4, ChargeCode_PulseInterval4,
ChargeCode_PulsesOnAnswer4;
[\ChargeCode]
Where,
 EndTime = Period (1 - 4) end time.